KUHN RIKON 5100 用户手册

5100TK OPR 6270US R060106

25

INSPECTION & ADJUSTMENTS

Safety Decals  for readability. If any safety decals are removed, obstructed, or otherwise not understandable,
they should be replaced immediately. Keep all decals clean - see Safety Decal section for more information.

Safety Shielding to be sure all shielding is in place and functioning properly.  Replace all damaged or missing
shielding immediately - see parts pages for more information.

Bolts and Set Screws after a few hours of use and each month thereafter. Tighten if necessary.

Auger Knives should be replaced when the long stem material is no longer sufficiently broke up, and there is a
noticeable increase in HP requirement.
Inspect knife fasteners to be sure they are tight.

IMPORTANT: WHEN WELDING ON THIS UNIT: Do Not allow the current to flow through the bearings, roller
chains, or scale weigh bars. Ground directly to the item being welded. ALWAYS disconnect weigh bar cords
from scale indicator before welding.

Rain can accumulate in mixer if stored outside, always leave the door partially open to allow unit to drain.

In freezing weather, snow can accumulate in mixer if stored outside, always leave the door partially open to
allow unit to drain melted snow and check hopper for snow or ice buildup before operating unit. Remove any ice
build up before use.

Always stop mixer, shut off the truck’s engine and remove the ignition key before servicing,
repairing or cleaning the machine.

If work must be done inside the mixer, put a protective cover over the auger knives to avoid
injury. The hopper floor and fighting may be slippery. Use caution when stepping on or standing
inside the machine.

Use safe shop procedures and exercise caution when working on the mixer!