Fujitsu MBA3147NC 用户手册
b. Format parameter (page code = 3)
Specify the number of spare sectors for each cell in the "alternate sectors/zone" field (cannot
be changed).
be changed).
(2)
FORMAT UNIT command
Initialize entire recording surface of the disk with the FORMAT UNIT command. The FORMAT
UNIT command initializes entire surface of the disk using the P lists, verifies data blocks after
initialization, and allocates an alternate block for a defect block detected with verification. With
initialization, the pattern specified with the initialization data pattern field is written into all bytes
of all logical data blocks. Only the position information of defect blocks detected with
verification is registered in the G list. The specifications are as follows:
UNIT command initializes entire surface of the disk using the P lists, verifies data blocks after
initialization, and allocates an alternate block for a defect block detected with verification. With
initialization, the pattern specified with the initialization data pattern field is written into all bytes
of all logical data blocks. Only the position information of defect blocks detected with
verification is registered in the G list. The specifications are as follows:
a. Specifying
CDB
Specify 0 for the "FmtData" bit and the "CmpLst" bit on CDB, 000 for the "Defect List
Format" field, and data pattern written into the data block at initialization for the "initializing
data pattern" field.
Format" field, and data pattern written into the data block at initialization for the "initializing
data pattern" field.
b. Format
parameter
When the values in step a. are specified with CDB, the format parameter is not needed.
88
C141-E270