Inglis Home Appliances 2225407 用户手册

Before you move your refrigerator into its final location, it is 
important to make sure you have the proper electrical 
connection:

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded 
electrical supply is required. It is recommended that a separate 
circuit serving only your refrigerator be provided. Use an outlet 
that cannot be turned off by a switch. Do not use an 
extension cord.

 Before performing any type of installation, cleaning, or 

removing a light bulb, turn the control (Thermostat, Refrigerator 
or Freezer Control depending on the model) to OFF and then 
disconnect the refrigerator from the electrical source. When you 
are finished, reconnect the refrigerator to the electrical source 
and reset the control (Thermostat, Refrigerator or Freezer Control 
depending on the model) to the desired setting.

Read all directions carefully before you begin.

■

If you turn the refrigerator on before the water line is 
connected, turn the ice maker OFF.

■

All installations must meet local plumbing code requirements.

■

Use copper tubing and check for leaks. Install copper tubing 
only in areas where temperatures will remain above freezing.

Standard screwdriver, 

⁷⁄₁₆ in. and ¹⁄₂ in. open-end 

wrenches or two adjustable wrenches, 

¹⁄₄ in. nut driver and drill 

bit, hand drill or electric drill (properly grounded).

 Your refrigerator dealer has a kit available with a 

¹⁄₄ in. 

(6.35 mm) saddle-type shutoff valve, a union, and copper tubing. 
Before purchasing, make sure a saddle-type valve complies with 
your local plumbing codes. Do not use a piercing-type or 

³⁄₁₆ in. 

(4.76 mm) saddle valve which reduces water flow and clogs more 
easily.

Connect the ice maker to a cold water line with water pressure 
between 30 and 120 psi. If you have questions about your water 
pressure, call your utility company.

Unplug refrigerator or disconnect power.

Turn OFF main water supply. Turn ON nearest faucet long 
enough to clear line of water.

Locate a ½ in. to 1

¹⁄₄ in. (1.25 cm to 3.18 cm) vertical COLD 

water pipe near the refrigerator.

 Horizontal pipe will work, but drill on the top side of 

the pipe, not the bottom. This will help keep water away from 
the drill and normal sediment from collecting in the valve.

Determine the length of copper tubing you need. Measure 
from the connection on the lower left rear of refrigerator to the 
water pipe. Add 7 ft. (2.1 m) to allow for cleaning. Use 

¹⁄₄ in. 

(6.35 mm) O.D. (outside diameter) copper tubing. Be sure 
both ends of copper tubing are cut square. 

Using a grounded drill, drill a 

¹⁄₄ in. hole in the cold water pipe 

you have selected.