Inglis Home Appliances 2225407 用户手册

6. Fasten the shutoff valve to the cold water pipe with the pipe 

clamp. Be sure the outlet end is solidly in the 

¹⁄₄ in. drilled hole 

in the water pipe and that the washer is under the pipe clamp. 
Tighten the packing nut. Tighten the pipe clamp screws 
carefully and evenly so washer makes a watertight seal. Do 
not overtighten or you may crush the copper tubing. 

7. Slip the compression sleeve and compression nut on the 

copper tubing as shown. Insert the end of the tubing into the 
outlet end squarely as far as it will go. Screw compression nut 
onto outlet end with adjustable wrench. Do not overtighten. 

8. Place the free end of the tubing in a container or sink, and 

turn ON the main water supply. Flush the tubing until water is 
clear. Turn OFF the shutoff valve on the water pipe. Coil the 
copper tubing.

1. Attach the copper tube to the valve inlet using a compression 

nut and sleeve as shown. Tighten the compression nut. Do 
not overtighten. Use the tube clamp on the back of the 
refrigerator to secure the tubing to the refrigerator as shown. 
This will help prevent damage to the tubing when the 
refrigerator is pushed back against the wall.

2. Turn shutoff valve ON. 

3. Check for leaks. Tighten any connections (including 

connections at the valve) or nuts that leak.

 

4. The ice maker is equipped with a built-in water strainer. If 

your water conditions require a second water strainer, install it 
in the 

¹⁄₄ in. (6.35 mm) water line at either tube connection. 

Obtain a water strainer from your nearest appliance dealer.

5. Plug in refrigerator or reconnect power.

TOOLS NEEDED: 

⁵⁄₁₆ in. hex-head socket wrench, No. 2 Phillips 

screwdriver, flat-head screwdriver, 

⁵⁄₁₆ in. open-end wrench, flat 2 

in. putty knife.

■

Before you begin, turn the refrigerator control OFF and 
unplug refrigerator or disconnect power. Remove food and 
adjustable door or utility bins from doors.

■

If you only want to remove and replace the doors, see the 
“Door and Hinge Removal” and “Door and Hinge 
Replacement” sections.

⁵⁄₁₆

1. Unplug refrigerator or disconnect power.

2. Open refrigerator door and remove base grille from the 

bottom front of the refrigerator (see Base Grille graphic).

3. Close the refrigerator door and keep both doors closed until 

you are ready to lift them free from the cabinet.

NOTE: Provide additional support for the doors while the 
hinges are being moved. Do not depend on the door magnets 
to hold the doors in place while you are working.

4. Remove the parts for the top hinge as shown in Top Hinge 

graphic. Lift the freezer door free from the cabinet.

5. Remove the parts for the center hinge as shown in the Center 

Hinge graphic. Lift the refrigerator door free from the cabinet.

6. Remove the parts for the bottom hinge as shown in the 

Bottom Hinge graphic.

IMPORTANT: If you want to reverse your doors so that they open 
in the opposite direction, follow these steps. If you are not 
reversing the doors, see “Door and Hinge Replacement.”