Husqvarna R120S 用户手册

English

 – 19

Clean the machine directly after use. It is much easier to wash 
off grass cuttings before they dry.

Oily dirt can be removed using a cold degreasing agent. 
Spray on a thin layer.

Rinse at normal water pressure.

Do not direct the jet towards electrical components or 
bearings.

Do not rinse hot surfaces such as the engine and exhaust 
system.

Hose down the cutting unit with water underneath each time 
it is used.

It is recommended that you start the engine and run the 
mower for a short period after cleaning, so that any remaining 
water is blown off.

Lubricate the machine if necessary after cleaning. Carry out 
extra lubrication when the bearings have been exposed to a 
degreaser or a water jet.

There is a major risk of water penetrating into bearings and 
electrical connections. Corrosion attack can result, which will 
lead to running problems. Cleaning additives generally 
aggravate the damage.

The engine becomes accessible for service when the engine 
cover is opened.

Loosen the snap locks (one on each side) and fold the cover 
backwards.

To remove the rear cover completely, pull it back sharply when 
in raised position. 

Release the clip on the right side of the mower deck and lift 
the cover off the mower deck.

Remove the screws and the back pedal knob, and lift off the 
cover.

Loosen the screws holding the wing cover and lift off the 
cover.

IMPORTANT! Avoid using a high pressure washer or a 
steam cleaner.