Raymarine ST1000 Plus & ST2000 Plus 用户手册

52

If necessary, reverse the operating sense can be reversed as follows:

1. Press -1 and +1 together for 5 seconds.
2. The display shows the new operating sense (port or starboard) for 

5 seconds, and then the autopilot reverts to normal operation.

If you have connected the tiller pilot to a navigator, check the 
interface as follows:

1. Set up a track on the navigator to give a Cross Track Error 

between 0 nm and 0.3 nm. 

2. Enter Auto mode by pressing auto.
3. Enter Track mode by pressing -10 and +10 together.
4. An alarm will sound and the display will alternate between the 

bearing to waypoint and the direction the boat will turn to 
acquire it.

5. Make sure that it is safe to turn onto the new course, then press 

-10 and +10 again.

6. If the navigator is connected correctly, the display will begin to 

cycle through the available navigation data: 

D208-2

D3267-2

Locked heading

Distance to waypoint
(if available)

Bearing to waypoint
(if available)

Cross track error

81130_3.book  Page 52  Wednesday, July 25, 2001  11:57 AM