Raymarine ST1000 Plus & ST2000 Plus 用户手册
54
Checking the wind instrument interface
If you have connected the tiller pilot to a wind instrument, check the
data link as follows:
data link as follows:
1. Press standby and auto together.
2. The tiller pilot should display a ‘W’ followed by the locked
2. The tiller pilot should display a ‘W’ followed by the locked
heading.
If the display continues to show a flashing ‘C’ and the current heading,
the tiller pilot is not receiving any wind data. The most likely reason is
a cabling error – either open circuit, short circuit or wires reversed.
the tiller pilot is not receiving any wind data. The most likely reason is
a cabling error – either open circuit, short circuit or wires reversed.
Checking the SeaTalk interface
If you have linked the tiller pilot to other instruments or control units
via SeaTalk, check the link as follows:
via SeaTalk, check the link as follows:
1. Press standby.
D3270-2
D3271-2
81130_3.book Page 54 Wednesday, July 25, 2001 11:57 AM