Novatel OM-20000041 用户手册
C
Commands Summary
MiLLennium GPSCard Software Version 4.50 Command Descriptions Manual Rev 1
121
SEND
This command is used to send ASCII printable data from the
COM1
or
COM2
or disk file to a specified
communications port. This is a one-time command, therefore the data message must be preceded by the
SEND
command followed by the <Enter> key (<CR><LF>) each time you wish to send data. (Remember to use the
MESSAGES
command to disable error reporting whenever two GPSCards are connected together via the
COM
ports.)
Syntax:
Scenario:
Assume that you are operating GPSCards as reference and remote stations. It could also be assumed
that the reference station is unattended but operational and you wish to control it from the remote station. From the
remote station, you could establish the data link and command the reference station GPSCard to send differential
corrections.
remote station, you could establish the data link and command the reference station GPSCard to send differential
corrections.
Figure C-4
Using SEND Command
SEND
to-port
data
Syntax
Range Value
Description
SEND
Command
to-port
COM1, COM2
Port option
data
up to 100 characters
ASCII data
COM 1
COM1
$PVAA data log...
send com1 log com 1 pvaa ontime 5
Host PC - Reference
(Operational with position fixed)
Host PC - Rover
Rover station is commanding Reference
to send PVAA differential logs
Serial Cables
messages com1 off
send com1 log com1 pvaa ontime 5
COM 2
COM 2