Sony 4-144-907-43(1) 用户手册

D:\NORM'S JOB\SONY HA\SO0056\STR-DA3500ES\CEL VERSION\GB\4144907431\01GB-
STRDA3500ESUC\090OTH_GB.fm

STR-DA3500ES
4-144-907-43(1)

For details on the Auto Calibration, see “9: 
Calibrating the appropriate speaker settings 
automatically (Auto Calibration)” (page 44).
See “Before you perform the Auto 
Calibration” (page 45) before performing the 
Auto Calibration.

Press GUI MODE repeatedly to select 
“GUI OFF”.

Press AMP.
Receiver operation is enabled.

Press MENU.

Press 

V/v repeatedly to select “<AUTO 

CAL>”, then press 

.

Press 

V/v repeatedly to select “A.CAL 

START”, then press 

 to start the 

measurement.
Measurement starts in five seconds. A 
count down is displayed.

While the time is counting down, stand away 
from the measurement area to avoid 
measurement error.

Measurement starts.
The measurement process will take 
approximately 30 seconds. Wait until the 
measurement process completes.

The measurement will be canceled when you 
do the following:
– Press ?/1, input buttons or MUTING.
– Press SPEAKERS (OFF/A/B/A+B) on the 

receiver.

– Change the volume level.
– Connect the headphones.
– Press GUI MODE.

• Operations other than turning the receiver on or off 

are deactivated during Auto Calibration.

• In the following situations, the measurements may 

not be performed correctly or Auto Calibration 
cannot be performed.
– when special speakers, such as dipole speakers 

are connected.

– when the multi zone function is used in zone 2/

zone 3.

Confirm the measurement result.
When the measurement ends, a beep 
sounds and the measurement result appears 
on the display window.

When the 
measurement 
process 
completes 
properly

COMPLETE Proceed to step 

2.

When the 
measurement 
process fails

E-
xxx:xx