Crown Boiler 24-06 用户手册

13

  FIELD ASSEMBLED SECTIONS — If the boiler 

was ordered to be field assembled, follow the assembly 

procedure outlined on the following pages.
1.  ASSEMBLY OF SECTIONS (MANUAL DRAW-

UP)

  These sections are designed to be drawn together, 

one section at a time, using the 9¾” long draw-up 

rods (provided) and ordinary hand tools.

  Tools required:

  (1) ¾” Drive Ratchet

  (1) 1-1/16” Socket

  (1) 1-1/16” Combination or Open End Wrench

  (1) Container of grease, oil or other appropriate 

lubricant.

a.  Place the rear section in its approximate final 

position, as outlined in Section I, and support it 

with a suitable prop and wedges.  See Figure 5.

b.  On size 24-03 only— Open target wall carton, 

apply Silastic to back of target wall and secure 

target wall to rear section.

c.  Clean the groove in the ground joint along the 

edge of the section with the wire brush.

d.  Open the Boiler Assembly Carton(s) and remove 

the bottle of adhesive. Using the dauber supplied 

in the bottle, apply the adhesive to the groove. 

Be sure to use enough adhesive to sufficiently 

coat the entire groove surface.  If so desired, 

a multi-purpose spray adhesive (supplied by 

others) may be used instead.  HOWEVER,  

GREAT  CARE  MUST  BE  TAKEN  TO  

ENSURE  THAT  THE  ADHESIVE  DOES  

NOT  COME  IN  CONTACT  WITH  THE  

NIPPLES  OR  NIPPLE  PORTS.

e.  Clean nipples and nipple ports thoroughly with 

a de-greasing solvent.  Use the Loctite #592 

supplied to lubricate the nipples and nipple 

ports.  Apply the lubricant to the nipples and 

nipple ports, then use a brush to disperse it 

evenly around the nipples and the nipple ports.  

Use approximately 25 ml of Loctite #592 per 

flueway [(1) 7” and (2) 3” nipples and their (6) 

corresponding nipple ports].

f.  Drive nipples squarely into section using 

block of wood and hammer, or preferably, 

an aluminum head hammer.  (Crown offers a 

Polyethylene Block for setting the nipples, part 

number 330010).  Place block over entire nipple 

edge and hit the wood with the hammer.