Crown Boiler 24-06 用户手册

14

g.  A special nipple setting gauge is provided for 

the nipples.  Gauge nipple in both directions to 

insure that it is driven to the proper depth into 

the nipple opening (nipple port).  Cut-out in 

gauge must rest on nipple, with legs of gauge 

touching finished face of section, when nipple is 

properly driven.  See Figure 6.

h.  Remove a 96” length of fiberglass rope from the 

assembly carton. Starting with the area around 

the upper 7” nipple port, firmly press the rope 

into the groove, so that the adhesive holds it in  

place. (If more than 25 minutes have passed 

since the adhesive was applied, it may be 

necessary to reapply.) Continue to affix the 

rope to the groove in this fashion around the 

perimeter of the section. Make sure that the rope 

does not droop or hang outside of the groove. 

When the end of the groove is reached, cut off 

the excess rope. Push the length of excess rope 

into the groove at the top corner of the section 

face (opposite of the 7” nipple port.) Cut off and 

discard any remaining rope after groove is filled. 

See Figure 7.