InSinkErator 14481 用户手册

WASTE INLET LINE

Connect.the.disposer.outlet.flange.as.close.as..
possible.and.with.as.few.as.possible.90°.elbows.to..
the.Waste.Xpress.inlet.

NOTE: The maximum allowable distance between the
disposer outlet flange and the Waste Xpress inlet is
10 feet with a maximum of four (4) 90° elbows.

1..Connect.the.disposer.outlet.to.the.Waste.Xpress..
. inlet.using.2".NPT.plumbing..3.HP.will.require.3"..
. outlet.adapter..The.run.between.the.disposer.and..
. Waste.Xpress.should.have.1/4".slope.per.foot.and..
. must.comply.with.all.local.codes.

NOTE: All horizontal runs should be as short as
possible (not to exceed 10 ft.), with an approximate
fall of 1/4" per foot.

TO REVERSE AUGER SCREEN:

A..Holding.both.handles.remove.discharge.chute..

of.the.Waste.Xpress.by.tilting.it.upward..
(see.Figure.13).

B..Remove.auger-bearing.bracket.by.sliding.the.two

captive.fasteners.inward.and.then.pull

bracket.upward.(see.Figure.14).

C..Lift.auger.and.screen.up.and.then.out..

(see.Figure.14).

D..Remove.auger.from.screen.by.lifting.up..

(see.Figure.15).

E..Remove.four.nuts.and.washers.holding.the.top..

portion.of.the.auger.screen.to.the.bottom.portion..
(see.Figure.16).

F..Rotate.bottom.portion.of.the.auger.screen.180°.

and.secure.to.top.portion.with.four.nuts.and..
washers.(see.Figure.17).

TO CHANGE WASTE INLET SIDE ON
WASTE XPRESS:

A..Remove.four.screws.holding.inlet.fitting.and..

gasket.in.position.(see.Figure.18).

B..Remove.four.screws.holding.the.cap.and.gasket.in.

position.(see.Figure.18).

C..Install.gaskets,.cap.and.inlet.fitting.on.reverse.side.

and.secure.with.appropriate.screws.

Figure 15.

Figure 16.

Figure 17.

Plumbing Connections

Nuts.&..

Washer.(4)

Auger

Screen

Inlet

Figure 18.

Waste.

Outlet

Waste.

Inlet

PROPERTY DAMAGE

Water.connections.must.comply.with.all.local.

plumbing.codes.