Husqvarna W3613ETS 用户手册

12

STARTING  AND OPERATING
ENGINE: START ENGINE AS FOLLOWS:
1. Move blade engagement lever to the off
position so the interlock will allow engine to
start.

2. Check gear shifter to be sure it is in the
neutral position.

3. While on level terrain, squeeze both drive
levers and lift up on the neutral bail to lock it into
the neutral lock position.

4. Open fuel shut-off valve

5. Set throttle control all the way forward to the
choke position.

6. Pull starter rope until engine starts.

7. Warm engine momentarily, then move the
throttle control out of the choke position until
engine runs smoothly, approximately 1/2 throttle.
Engage the blades and set the desired rpm.
The best cutting and bagging is obtained with
engine at or near top rpm.

8. Depress one operator presence lever and
shift transmission to the desired gear.

9. Unlock the drive levers by pushing the neutral
bail down out of the neutral slots. Slowly release
both drive levers at the same time to begin
forward motion.

10. The steering system of this mower uses
individual right and left drive levers on the handle
bars.  Squeezing the drive lever will reduce
tension on the wheel drive belt eliminating power
to that wheel.  With the opposite wheel still
under power a turn is accomplished.  If the drive
lever is squeezed even tighter the brake will be
applied to that wheel and a tighter more abrupt
turn is accomplished. - turn left by squeezing
the left hand drive lever or turn right by squeez-
ing the right hand drive lever. If you squeeze
both levers the mower will stop. See figure to
right of page.