Husqvarna W3613ETS 用户手册
14
CUTTER HOUSING SPINDLE ASSEMBLIES
The cutter housing assembly is designed with a
slip fit inner race and pulley. The sole purpose
of the setscrew in the pulley is to hold the
housing assembly together. The setscrew is
not meant to secure the pulley. The pulley is
secured by pinching the pulley to the inner race
of the bearings using the blade bolt and nut.
Tighten the setscrews after you have pinched
the assembly together with the blade bolt and
nut.
Each cutter spindle on 48" Models have a
different stack up of spacers and pulleys, to
achieve proper belt alignment. The left cutter
spindle on 48" Models is the same as 36"
Models. See figure #8 (Refer to the parts
manual when ordering parts.)
The cutter housing assembly is designed with a
slip fit inner race and pulley. The sole purpose
of the setscrew in the pulley is to hold the
housing assembly together. The setscrew is
not meant to secure the pulley. The pulley is
secured by pinching the pulley to the inner race
of the bearings using the blade bolt and nut.
Tighten the setscrews after you have pinched
the assembly together with the blade bolt and
nut.
Each cutter spindle on 48" Models have a
different stack up of spacers and pulleys, to
achieve proper belt alignment. The left cutter
spindle on 48" Models is the same as 36"
Models. See figure #8 (Refer to the parts
manual when ordering parts.)
Cutter housing assemblies use sealed bearings
and are maintenance free.
and are maintenance free.
NOTE
WHEN PRESSING A BEARING IN OR OUT
OF A CUTTER HOUSING APPLY CONSTANT
PRESSURE TO THE RACE OR RACES
THAT HAVE AN INTERFERENCE FIT.
NEVER BEAT A BEARING IN OR OUT.