ATTO Technology H308 用户指南
12
CAUTION
CAUTION
Do not exceed the torque specification to
avoid damaging the board, connectors or
screws.
avoid damaging the board, connectors or
screws.
6
Insert the ATTO ExpressSAS host adapter into
any open 2.0/1.2 PCI Express expansion slot. If
you have questions about how to install an
expansion card in your system, consult your
computer’s documentation.
any open 2.0/1.2 PCI Express expansion slot. If
you have questions about how to install an
expansion card in your system, consult your
computer’s documentation.
7
Close the case on the computer and power it
up.
up.
8
Installed drivers are loaded.
For Windows 2000, XP and Server 2003
• Windows detects your ExpressSAS Adapter
For Windows 2000, XP and Server 2003
• Windows detects your ExpressSAS Adapter
and the
Found New Hardware wizard
appears. Proceed through the wizard with
the default settings for each adapter
the default settings for each adapter
channel. Insert the ExpressSAS installation
disk when prompted.
disk when prompted.
• After adapter installation is complete, the
Found New Hardware wizard shows an
ATTO Phantom Device for each channel.
Proceed through the wizard with default
settings to complete the installation.
ATTO Phantom Device for each channel.
Proceed through the wizard with default
settings to complete the installation.
For Windows Vista and Server 2008
• Windows detects your adapter and
• Windows detects your adapter and
automatically installs the required drivers.
If drivers do not load, refer to
Install Drivers
on
page 5 and
9
Turn off power to the computer.
10 Continue to
ExpressSAS R348 only
At shipping, the ExpressSAS R348 has an 8x internal
port configuration. You may change the adapter to use
a 4xinternal port and 4x external port configuration.
1
port configuration. You may change the adapter to use
a 4xinternal port and 4x external port configuration.
1
Power on your computer.
2
Launch the ATTO Configuration Tool from the
Installation CD. For Configuration Tool
instructions, refer to the ATTO Utilities
Installation and Operation Manual, also on the
Installation CD.
Installation CD. For Configuration Tool
instructions, refer to the ATTO Utilities
Installation and Operation Manual, also on the
Installation CD.
3
From the left hand panel
Device Listing,
expand all the elements in the
hosts tree.
4
Find the ExpressSAS adapter and click on the
Channel 1 entry in the tree.
Channel 1 entry in the tree.
5
Change the
Port Configuration from 8
Internal to 4 Intrn, 4 Extrn.
6
Click on
Commit.
7
Exit the Configuration Tool application.
8
Power down the computer and unplug the
computer from all power sources.
computer from all power sources.
9
Continue to