Sanyo PLC-WXU700A 用户手册

To ensure safe operation, please observe the following precautions :

  ●  Use two (2) AAA or LR03 type alkaline batteries.

  ●  Always replace batteries in sets.

  ●  Do not use a new battery with a used battery.

  ●  Avoid contact with water or liquid.

  ●  Do not expose the remote control to moisture or heat.

  ●  Do not drop the remote control.

  ●  If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

  ●  Risk of an explosion if battery is replaced by an incorrect type. 

  ●  Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Press the lid 

downward and slide it.

Open the battery 

compartment lid.

Install new batteries 

into the compartment.

Replace the 

compartment lid.

For correct polarity 

(+ and –), be sure 

battery terminals are 

in contact with pins in 

compartment.

Point the remote control toward the projector when pressing 

the buttons. Maximum operating range for the remote 

control is about 16.4'(5 m) and 60 degrees in front of the 

projector.

16.4'
(5 m)

30°

Remote control

30°

While pressing the MENU 

button, press the IMAGE 

button number of times 

corresponding to the remote 

control code. 

The eight different remote control codes (Code 1 – Code 8) are assigned to this projector. Switching the remote 

control codes prevents interference from other remote controls when several projectors or video equipment 

next to each other are operated at the same time. Change the remote control code for the projector first before 

changing that for the remote control. See "Remote control" in the Setting Menu on page 58.

While pressing the MENU button, press the IMAGE 

button number of times corresponding to the remote 

control code. See the list below.

To initialize the remote control code, slide the RESET/ 

ON/ALL-OFF switch to 

RESET, and then to ON. The 

initial code is set to 

Code 1.