Sanyo PLC-WXU700A 用户手册

LASER button

PRESENTATION POINTER 

button

This remote control emits a laser beam from the laser light window. Press the LASER button to activate the 

laser pointer. The signal emission indicator lights red and the red laser beam is emitted. If the LASER button is 

pressed for more than one minute or if it is released, the laser light goes off.

The laser emitted is a Class II laser. Do not look into the laser light window or point the laser beam at yourself or 

other people. The following is the caution label for the laser beam.

CAUTION:   Use of controls, adjustments or performance of procedures other than those specified herein may 

result in hazardous radiation exposure. Never look directly into the laser light window while a laser 

is emitted, otherwise eye damage may result. 

The caution label is put on the remote control.

You can move the Spotlight or Pointer of the projector with the remote control to emphasize a part of the 

projected image.  

Press and hold the MENU and the NO SHOW buttons 

for more than 5 seconds to activate the Pointer function. 

(The Laser pointer has switched to the Pointer function.)

Press the LASER button on the remote control pointing 

toward the projector. The Spotlight or Pointer is 

displayed on the screen with the LASER button lighting 

green. Then move the Spotlight or Pointer with the 

PRESENTATION POINTER button. If the LASER button 

does not light green and continues to emit a laser beam, 

try the abovementioned procedure until the LASER 

button lights green. 

To clear the Spotlight or Pointer out the screen, press 

the LASER button pointing toward the projector and see 

if the LASER button lighting is turned off.

To switch to the Laser pointer again, press and hold the 

NO SHOW and MENU buttons for more than 5 seconds 

or slide the RESET/ON/ALL-OFF switch to 

RESET and 

then to 

ON.

When you reset the Pointer function, the remote control 

code will be reset, as well. 



    You can choose the size of Spotlight (Large/Middle/

Small) and the pattern of Pointer (Arrow/Finger/Dot) in 

the Setting Menu. See “Pointer” on page 54.

After the Laser pointer has 

switched to the Pointer, use 

the LASER button as the 

Pointer function ON-OFF 

switch. Press the LASER 

button pointing toward the 

projector and see if it lights 

green.

Laser Light Window

Signal Emission Indicator

MENU button
NO SHOW button
Press and hold the MENU 

and NO SHOW buttons for 

more than 5 seconds.

PRESENTATION POINTER 

button

ない。