Alcatel-Lucent 6850-48 网络指南

Configuring IP Multicast VLAN

Configuring IPMVLAN

OmniSwitch AOS Release 6 Network Configuration Guide

page 43-9

This section describes how to use Command Line Interface (CLI) commands to complete the following 
configuration tasks:

• Creating and deleting IPMVLAN (see 

• Assigning IPv4/IPv6 address to an existing IPMVLAN and removing it (see 

• Assigning and removing the c-tag in an IPMVLAN (see 

• Creating and deleting a sender port in an IPMVLAN (see 

• Creating and deleting a receiver port in an IPMVLAN (see 

• Configuring a VLAN translation of a CVLAN to an IPMVLAN (see 

).

In addition, a tutorial is provided in 

 that shows you 

how to use CLI commands to configure a sample network.

Note. See the “IP Multicast VLAN Commands” chapter in the OmniSwitch CLI Reference Guide for 
complete documentation of IPMVLAN CLI commands.

The following subsections describe how to create and delete an IPMVLAN with the 

 

command.

Note. The Enterprise mode is the default mode of an IP Multicast VLAN.

To create an IPMVLAN, use the 

 command as shown below:

-> vlan ipmvlan 1003 name 

"multicast vlan" 

For example, to create an IPMVLAN in the 1x1 Spanning Tree mode, enter:

-> vlan ipmvlan 1333 1x1 stp enable name “nvlan”