Alcatel-Lucent 6850-48 网络指南

Modifying Dynamic Link Aggregate Group Parameters

Configuring Dynamic Link Aggregation

page 23-14

OmniSwitch AOS Release 6 Network Configuration Guide

The table on 

 lists default group and port settings for Alcatel-Lucent’s dynamic link aggregation 

software. These parameters ensure compliance with the IEEE 802.3ad specification. For most networks, 
these default values do not need to be modified or will be modified automatically by switch software. 
However, if you need to modify any of these default settings see the following sections to modify parame-
ters for:

• Dynamic aggregate groups beginning on 

• Dynamic aggregate actor ports beginning on 

• Dynamic aggregate partner ports beginning on 

Note. You must create a dynamic aggregate group before you can modify group or port parameters. See 

 for more information.

This section describes how to modify the following dynamic aggregate group parameters:

• Group name (see 

• Group administrative state (see 

• Group local (actor) switch actor administrative key (see 

)

• Group local (actor) switch system priority (see 

)

• Group local (actor) switch system ID (see 

• Group remote (partner) administrative key (see 

)

• Group remote (partner) system priority (see 

)

• Group remote (partner) switch system ID (see 

The following subsections describe how to configure and remove a dynamic aggregate group name with 
the 

 command.

To configure a dynamic aggregate group name, enter lacp linkagg followed by the dynamic aggregate 
group number, name, and the user-specified name, which can be from 1 to 255 characters long.