Alcatel-Lucent 6850-48 网络指南

Configuring Dynamic Link Aggregation

Modifying Dynamic Link Aggregate Group Parameters

OmniSwitch AOS Release 6 Network Configuration Guide

page 23-15

For example, to name dynamic aggregate group 4 “Engineering” you would enter:

-> lacp linkagg 4 name Engineering

Note. If you want to specify spaces within a name, the name must be enclosed in quotes. For example:

-> lacp linkagg 4 name "Engineering Lab"

To remove a dynamic aggregate group name from a switch’s configuration use the no form of the 

 command by entering lacp linkagg followed by the dynamic aggregate group number and 

no name.

For example, to remove any user-configured name from dynamic aggregate group 4 you would enter:

-> lacp linkagg 4 no name

By default, the dynamic aggregate group administrative state is enabled. The following subsections 
describe how to enable and disable a dynamic aggregate group’s administrative state with the

To enable the dynamic aggregate group administrative state, enter lacp linkagg followed by the dynamic 
aggregate group number and admin state enable. For example, to enable dynamic aggregate group 4 you 
would enter:

-> lacp linkagg 4 admin state enable

To disable a dynamic aggregate group’s administrative state, use the 

by entering lacp linkagg followed by the dynamic aggregate group number and admin state disable.

For example, to disable dynamic aggregate group 4 you would enter:

-> lacp linkagg 4 admin state disable

The following subsections describe how to configure and delete a dynamic aggregate group actor adminis-
trative key with the 

 command.

To configure the dynamic aggregate group actor switch administrative key enter lacp linkagg followed by 
the dynamic aggregate group number, actor admin key, and the value for the administrative key, which 
can be 0 through 65535.

For example, to configure dynamic aggregate group 4 with an administrative key of 10 you would enter:

-> lacp linkagg 4 actor admin key 10