Alcatel-Lucent 6850-48 参考指南

Virtual Private LAN Service (VPLS) Commands

OmniSwitch CLI Reference Guide

September 2009

page 26-47

configure service vpls mesh-sdp ingress vc-label

Configures the static MPLS VC label used by the far-end router to send packets to this router using the
specified mesh SDP binding.

configure service vpls service-id mesh-sdp sdp-id[:vc-id] ingress vc-label ingress-vc-label

configure service vpls service-id no mesh-sdp sdp-id no ingress vc-label

Syntax Definitions

service-id

An existing VPLS ID number.

sdp-id

An existing SDP ID number that is bound to the specified service ID
number.

vc-id

A VC ID number used to validate the VC ID portion of each mesh SDP
binding defined for the service.

vc-label

The ingress VC value that identifies a specific connection. The valid
range is 2048–18431.

Defaults

By default, the ingress VC label value is set to zero (0).

Platforms Supported

OmniSwitch 9000E

Usage Guidelines

Use the no form of this command to remove the ingress VC label from the specified VPLS.

Examples

-> configure service vpls 100 mesh-sdp 20 ingress vc-label 131069

-> configure service vpls 100 mesh-sdp 20 ingress no vc-label

Release History

Release 6.4.2; command was introduced.

parameter

default

vc-id

service-id value