Alcatel-Lucent 6850-48 参考指南
Ethernet OAM Commands
OmniSwitch CLI Reference Guide
September 2009
page 28-9
ethoam association mhf
Modifies the MIP Half Function
(
MHF) value of an Ethernet OAM Maintenance Association.
ethoam association association_name domain {domain_name | mac_address} mhf {none | explicit |
default}
default}
Syntax Definitions
association_name
Name of the Ethernet OAM Association. Up to 48 (minus the domain
name length) characters may be used.
name length) characters may be used.
domain_name
Specifies the domain name. For more information on the different
formats of the domain name, refer to
formats of the domain name, refer to
mac_address
Specifies the CFM system MAC address.
none
Specifies that no MHFs can be created for the specified VLAN ID.
explicit
Specifies that MHFs can be created for the specified VLAN ID only on
Bridge ports through which this VLAN ID can pass and only if a Main-
tenance End Point (MEP) is created at a lower MA level.
Bridge ports through which this VLAN ID can pass and only if a Main-
tenance End Point (MEP) is created at a lower MA level.
default
Specifies that MHFs can be created on the specified VLAN ID on any
Bridge port through which this VLAN ID can pass.
Bridge port through which this VLAN ID can pass.
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
The association_name should be unique amid all those used by or available to the service provider within
a domain.
a domain.
Examples
-> ethoam association alcatel-sales domain esd.alcatel-lucent.com mhf none
Release History
Release 6.2.1; command was introduced.
Release 6.3.1; mac_address parameter added.
Release 6.3.1; mac_address parameter added.
parameter
default
none | explicit | default
none