Alcatel-Lucent 6850-48 参考指南
Power over Ethernet (PoE) Commands
OmniSwitch CLI Reference Guide
September 2009
page 4-3
lanpower start
Activates Power over Ethernet on a single specified PoE port or on all PoE ports in a specified slot.
lanpower start {slot/port[-port2] | slot}
Important. Inline power is not activated until the lanpower start slot syntax is issued for the applicable
PoE slot(s).
PoE slot(s).
Syntax Definitions
slot/port
Activates inline power on the specified PoE port only. This syntax is
used to re-enable power to an individual port that has been manually
turned off via the
used to re-enable power to an individual port that has been manually
turned off via the
command.
port2
The last port number in a range of ports that you want to configure on
the same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
the same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
slot
Activates inline power on all PoE ports in the corresponding slot.
Defaults
Power over Ethernet operational status is globally disabled by default.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000
Usage Guidelines
Use the slot/port syntax to activate power on a particular port. When all ports in a slot are manually turned
off, use only the slot syntax in the command line. This activates power on all ports in the specified slot. As
noted above, inline power is not active until the lanpower start slot syntax is issued for the applicable
PoE slot(s).
off, use only the slot syntax in the command line. This activates power on all ports in the specified slot. As
noted above, inline power is not active until the lanpower start slot syntax is issued for the applicable
PoE slot(s).
Examples
-> lanpower start 5/11
-> lanpower start 5
-> lanpower start 5/11-14
Release History
Release 6.1; command was introduced.