Alcatel-Lucent 6850-48 参考指南

PIM Commands

page 45-110

OmniSwitch CLI Reference Guide

Displays the IPv6 PIM group mapping table.

N/A

If the keywords bsr, static-rp, ssm, or dense are included in the command line, then only the entries that 
were created by the specified origin are displayed.

OmniSwitch 6850, 6855, 9000, 9000E

• If static RP configuration is being used, this information is obtained from those static RP addresses that 

are defined via the 

 command. As long as the RP addresses defined in the static RP 

set are reachable, they will be added to the group mapping table.

• If the IPv6 multicast groups are mapped to the mode DM or SSM, then the entries created by local 

SSM address range configuration using the 

 command and local Dense Mode 

address range configuration using the

 

 

command are displayed.

• If the Bootstrap mechanism is being used, this information is obtained from received Candidate-RP 

advertisements (when the local router is the BSR; when the local router is not the BSR, this informa-
tion is obtained from received Bootstrap messages). 

-> show ipv6 pim group-map

Origin    Group Address/Pref Length   RP Address    Mode  Precedence 

---------+---------------------------+-------------+-----+-----------

BSR       ff00::/8                    3000::11      asm   192

BSR       ff00::/8                    4000::7       asm   192

SSM       ff33::/32                                 ssm   

-> show ipv6 pim group-map bsr

Origin    Group Address/Pref Length   RP Address    Mode  Precedence 

---------+---------------------------+-------------+-----+-----------

BSR       ff00::/8                    3000::11      asm   192

BSR       ff00::/8                    4000::7       asm   192

-> show ipv6 pim group-map ssm

Origin     Group Address/Pref Length   RP Address    Mode  Precedence 

---------+---------------------------+-------------+-----+-----------