Alcatel-Lucent 6850-48 参照ガイド
PIM Commands
page 45-110
OmniSwitch CLI Reference Guide
September 2009
show ipv6 pim group-map
Displays the IPv6 PIM group mapping table.
show ipv6 pim group-map [bsr | static-rp | ssm | dense]
Syntax Definitions
N/A
Defaults
If the keywords bsr, static-rp, ssm, or dense are included in the command line, then only the entries that
were created by the specified origin are displayed.
were created by the specified origin are displayed.
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
• If static RP configuration is being used, this information is obtained from those static RP addresses that
are defined via the
command. As long as the RP addresses defined in the static RP
set are reachable, they will be added to the group mapping table.
• If the IPv6 multicast groups are mapped to the mode DM or SSM, then the entries created by local
SSM address range configuration using the
command and local Dense Mode
address range configuration using the
command are displayed.
• If the Bootstrap mechanism is being used, this information is obtained from received Candidate-RP
advertisements (when the local router is the BSR; when the local router is not the BSR, this informa-
tion is obtained from received Bootstrap messages).
tion is obtained from received Bootstrap messages).
Examples
-> show ipv6 pim group-map
Origin Group Address/Pref Length RP Address Mode Precedence
---------+---------------------------+-------------+-----+-----------
BSR ff00::/8 3000::11 asm 192
BSR ff00::/8 4000::7 asm 192
SSM ff33::/32 ssm
-> show ipv6 pim group-map bsr
Origin Group Address/Pref Length RP Address Mode Precedence
---------+---------------------------+-------------+-----+-----------
BSR ff00::/8 3000::11 asm 192
BSR ff00::/8 4000::7 asm 192
-> show ipv6 pim group-map ssm
Origin Group Address/Pref Length RP Address Mode Precedence
---------+---------------------------+-------------+-----+-----------