BTC btop10 用户指南
2.2 Switch
1. power slide switch
o
: power off
I
: power on
2. Link tact switch:
push this LINK switch slightly will enable bluetooth PAIRING
function(bluetooth LED will blink quickly)
function(bluetooth LED will blink quickly)
NOTE:
1. Linking need to be done one time only when users use GPS and connect
1. Linking need to be done one time only when users use GPS and connect
with PDA..etc device in first time
2. Unless users have another PDA or Bluetooth enable device for BTC GPS,
other wise users don’t need to push this switch
WARNING:
1. Linking switch may not be activated by all bluetooth connection
condition, please turn off power first, and then
push slightly Paring switch again if any problem to this issue.
3. DC5V:
plug with car charger or travel charger to charge battery
(input:
DC
5V,
500mA)
2.3 RF Connector
Built in MMCX RF connector (external active antenna is optional)
WARNING:
1. Due to the size of the MMCX RF connector is quite compacted, so please
use BTC external active antenna with MMCX plug, or other external antenna which have been approved by
BTC.
1. Due to the size of the MMCX RF connector is quite compacted, so please
use BTC external active antenna with MMCX plug, or other external antenna which have been approved by
BTC.
3. Quick start
First
step:
charging
battery more than 5 hours
Before using bluetooth GPS receiver, battery have to be charged first,
Connect travel charger or car charger with GPS receiver DC5V Jack.
Charging the battery until the battery LED from orange color becomes Green color.
Connect travel charger or car charger with GPS receiver DC5V Jack.
Charging the battery until the battery LED from orange color becomes Green color.
6