Humminbird one deep 安装指导

 

 

Your Humminbird fishfinder includes a standard 
transducer. This transducer can be mounted on the 
transom of the boat or bonded to the inside of a fiberglass 
hull boat. 

 

The transom installation, which is the most widely used, 
places the transducer on the outside of the boat hull. This 
technique produces the least signal loss, and provides a 
way to adjust the transducer after installation. The 
mounting hardware included is designed to protect both 
the boat and the transducer should the boat strike debris in 
the water or when trailering. 

 
As an alternative to transom mounting, it is possible on many 
fiberglass-hulled boats to glue the transducer on the inside of 
the boat hull. Since fiberglass has similar sonar 
characteristics as water, the sonar signal can pass through 
the boat hull with minimal loss. The hull of the boat must be 
single layer construction (not double-hulled) Also, any air 
trapped in the lamination of the fiberglass would prevent the 
sonar signal from passing through. 
 
Inside the hull installations require no holes be drilled into the 
boat and through experimentation, high-speed operation 
comparable to transom mounting can be achieved. Two-part 

slow cure epoxy (not included) is required to glue the transducer in place.