RCA 23200re3 用户指南

Installing the Handset Battery

NOTE: You must connect the handset battery before use.

1. Push down on the top of the battery compartment cover (located on the back of each handset)

and remove the cover.

2. Plug the battery pack cord into the jack inside the battery compartment.

NOTE: It is important to maintain the polarity (black and red wires) to the jack inside the

compartment. To ensure proper battery installation, the connector is keyed and can be inserted

only one way.

3.  Insert the battery pack.
4.   Close the battery compartment by pushing the door up until it snaps into place.
5.   Place the handset in the charging cradle.

Allow handset to charge for 16 hours prior to ﬁrst use. If you don’t properly charge the

handset, battery performance is compromised.

NOTE: If the battery is not properly installed in the handset, or if the battery pack is not properly

connected to the jack inside the battery compartment. “NO BATTERY” shows in the display when

the handset is placed in the charging cradle.

Installing the Docking Station

NOTE: Prior to installing the docking station, make sure the base unit has been installed.

Choose the best location to install the docking station, it should be placed on a level surface such as

a desk or table top.
1. Plug one end of the docking station power adaptor cord into the power jack on the back of the

docking station and the other end into an electrical outlet. Docking station display will show

DOCKING STATION after a few seconds.

BLACK WIRE

RED WIRE

BATTERY

PRESS DOWN

FIRMLY

Connections & Setup