Mitsubishi wd-57833 业主指南

To perform this procedure, you need:

•  The remote controls for both the TV and the 

device you want to control.

•  The IR emitter cable supplied with the TV.

Note:  To set up an A/V receiver, see “Set Up 

NetCommand Control of an A/V Receiver” later 
in this chapter.

1.  Connect and position the IR emitters for the 

devices you wish to control.  See “IR Emitter Place-
ment” in this chapter.

2.  Set the 

TV’s remote control slide switch to the TV 

position.

3.  Open the NetCommand 

Learn screen in one of two 

ways:
•  If working from the 

Auto Input Sensing screen 

for the device, highlight the 

Learn icon and 

press 

ENTER to open the Learn screen for the 

device.

•  If performing NetCommand setup at any time 

after the device has been recognized through 
Auto Input Sensing:
a.  Press 

INPUT to open the Input Selection 

menu.

b.  Highlight the desired input icon and press 

ENTER to switch to that input.

c.  Press 

MENU, highlight Inputs, and highlight 

Learn to open the Learn screen for the 
device.

4.  The first function highlighted in the 

Learn screen 

is always 

Power On.  Aim the TV’s remote control 

at the TV and press 

ENTER to begin learning for that 

function.

5.  When the 

Power On text starts flashing, aim the 

device’s remote control at the TV and press and 
hold the 

POWER key until a check mark appears next 

to 

Power On.

•  If the text stops flashing before the check mark 

appears, repeat this step.

•  To remove the key from NetCommand control, 

press the 

CANCEL key while the key name is 

highlighted.

6.  Press the          keys on the 

TV’s remote control 

to highlight other keys on the list.  Repeat steps 
4 and 5 for each additional function you wish to 
control through NetCommand.

7.  If the device’s remote control has keys that are not 

in the list, you can associate up to any four keys 
with the 

F1 through F4 keys.

For example, for a DVD player, assign the 

F1 and 

F2 keys to the DVD player’s CHAPTER SKIP FORWARD and 
CHAPTER SKIP BACK keys.  Perform NetCommand setup 

for the 

F keys the same as you did for the named 

keys

8.  If the device has a separate 

POWER OFF key, press   

      on the 

TV’s remote to highlight Power Off.  

Repeat the earlier steps to “learn” the 

POWER OFF key.

9.  Press 

EXIT to finish NetCommand “learning” for the 

current device.

1.  Press 

INPUT to open the Input Selection menu and 

select the affected device.

2.  Open the 

Inputs menu and highlight the Learn icon.

3.  When the 

Learn screen displays:

•  To add keys:  Continue as described earlier 

under “Initial NetCommand Setup for Most 
Device Types.”

•  To delete keys:  Highlight the name of the key 

you wish to delete and press 

CANCEL on the TV‘s 

remote control to clear the check mark.