Sony STR-DA3400ES 快速安装指南
119
GB
D:\NORM'S JOB\SONY HA\STR-DA3400ES\CEL\3289137411\01GB-
STRDA3400ESUC\110ADD_GB.fm
STRDA3400ESUC\110ADD_GB.fm
masterpage: Right
STR-DA3400ES
3-289-137-41(1)
3-289-137-41(1)
Ad
ditional Inf
ditional Inf
o
rmation
The Control for HDMI function does not
work.
work.
• Check the HDMI connection (page 76).
• Make sure “Control for HDMI” is set to
• Make sure “Control for HDMI” is set to
“ON” in the HDMI settings menu.
• Make sure the connected component is
compatible with the Control for HDMI
function.
function.
• Check the Control for HDMI settings on
the connected component. Refer to the
operating instructions of the connected
component.
operating instructions of the connected
component.
• Repeat the procedures of “Preparing
Control for HDMI function” if you change
the HDMI connection, connect/disconnect
the AC power cord (mains lead), or when
there is a power failure (page 77).
the HDMI connection, connect/disconnect
the AC power cord (mains lead), or when
there is a power failure (page 77).
No sound is output from the receiver
and TV speaker while using the System
Audio Control function.
and TV speaker while using the System
Audio Control function.
• Make sure the TV is compatible with the
System Audio Control function.
• If the TV does not have System Audio
Control function, set the “Audio Out”
settings in HDMI settings menu to
– “TV+AMP” if you want to listen to the
settings in HDMI settings menu to
– “TV+AMP” if you want to listen to the
sound from the TV speaker and receiver.
– “AMP” if you want to listen to the sound
from the receiver.
• If you cannot listen to the sound of a
component connected to the receiver
– Change the input of the receiver to
– Change the input of the receiver to
HDMI when you want to watch a
program on a component connected via
HDMI connection to the receiver.
program on a component connected via
HDMI connection to the receiver.
– Change the TV channel when you want
to watch a TV broadcast.
– Select the component or input you want
to watch when you watch a program on
the component connected to the TV.
Refer to the operating instructions of the
TV on this operation.
the component connected to the TV.
Refer to the operating instructions of the
TV on this operation.
The TV’s remote commander cannot be
used to control the connected
component when using the Control for
HDMI function.
used to control the connected
component when using the Control for
HDMI function.
• Change the input of the receiver to the
HDMI input connected to the component.
Tuner
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna (aerial) as shown below. If you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground (earth) wire to a gas pipe.
antenna (aerial) as shown below. If you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground (earth) wire to a gas pipe.
Receiver
To ground
Ground (earth)
wire (not supplied)
wire (not supplied)
Outdoor FM antenna (aerial)
continued