Roland juno-stage 用户指南
133
Chapter 10. Detailed Editing for Performances
When you use a patch (or rhythm set) in Performance mode, its effects
and some other settings will be affected by the settings of the
performance. To edit the patch (or rhythm set) in the context of these
performance settings, proceed as follows.
and some other settings will be affected by the settings of the
performance. To edit the patch (or rhythm set) in the context of these
performance settings, proceed as follows.
1.
Make sure that [PERFORM] is lit.
2.
Press [EDIT].
3.
Either press [3], or use the VALUE dial to select “PATCH EDIT” (or
“RHYTHM EDIT”) and press [ENTER].
“RHYTHM EDIT”) and press [ENTER].
Now you can edit the patch that’s assigned to the currently
selected part. For details on patch editing, refer to “Chapter 8.
Detailed Editing for Patches” (p. 94) or “Chapter 9. Detailed
Settings for a Rhythm Set” (p. 120).
selected part. For details on patch editing, refer to “Chapter 8.
Detailed Editing for Patches” (p. 94) or “Chapter 9. Detailed
Settings for a Rhythm Set” (p. 120).
After you’ve finished editing the patch, press [WRITE] to save the
patch (p. 133).
patch (p. 133).
Changes you make are temporary, and will be lost when you turn off
the power or select another performance. If you want to keep the
performance you’ve edited, you must save it to internal user memory.
the power or select another performance. If you want to keep the
performance you’ve edited, you must save it to internal user memory.
If you’ve edited a performance, an “*” will be shown in the PERFORM
PLAY screen.
PLAY screen.
When you save, the data that previously occupied the save
destination will be overwritten.
destination will be overwritten.
1.
Edit a performance.
2.
Press [WRITE].
The WRITE MENU screen will appear.
3.
Press [2 (PERF)].
Alternatively, you can use [
] [
] to select “Performance,”
and then press [ENTER].
The PERFORMANCE NAME screen will appear.
4.
Assign a name to the performance.
5.
When you’ve finished assigning a name, press [7 (WRITE)].
A screen allowing you to select the save destination will appear.
6.
Use the VALUE dial, [DEC] [INC], or [
] [
] to select the save-
destination performance number.
7.
Press [7 (WRITE)].
A confirmation message will appear.
If you decide to cancel, press [6 (CANCEL)].
8.
Press [7 (EXEC)] to save the performance.
Never turn off the power while data is being saved.
If You’ve Edited a Patch or Rhythm Set
Assigned to a Part of the Performance
If you’ve edited a patch or rhythm set assigned to a part of the
performance and attempt to save the performance without having
saved the edited patch or rhythm set, a message like the following will
appear.
performance and attempt to save the performance without having
saved the edited patch or rhythm set, a message like the following will
appear.
fig.disp-perfwrite.eps
In this case, save the patch or rhythm set before you save the
performance.
performance.
Editing the Patch That’s Assigned
to a Part
Saving a Performance You’ve Created
([WRITE])
JUNO-STAGE_e.book 133 ページ ２００８年１０月１７日 金曜日 午後１２時２７分