Roland v-synth xt 业主指南

Creating a Patch

Key Sync (Step modulator key sync)

This specifies whether the step sequence will be reset (i.e., will play
from the beginning) when a note-on occurs.

Value

Off:

The step sequence will not be reset when a note-on occurs.

Part:

The step sequence will be reset when a note-on occurs, but will

not be reset if the key was played legato.

Voice:

The step sequence will be reset each time a note-on occurs.

* This setting applies to all tracks (Track A–D).

Track Button A–D (Step modulator track
buttons A–D)

These turn the multi step modulator on/off for the four tracks (A–
D).

Value:

OFF, ON

Track TAB A–D (Step modulator track tabs A–
D)

These access the editing screens for the four multi step modulator
tracks (A–D).

Loop (Step modulator loop switch)

This turns looping on/off for the step sequence.

Value:

OFF, ON

Grid (Step grid)

This specifies the note value of each step.

Value:

End P (Step modulator end point)

This specifies the sequence length as a number of steps.

Value:

1–16

Dir (Step modulator direction)

This specifies the direction in which the step sequence will play.

Value:

Zone (Step modulator zone)

This specifies the zone to which the step modulator will be applied.

Value:

1–16

Destination (Step modulator destination)

The parameter that is controlled by the step sequence will depend on
the patch. Touch < List > to change the parameter that is controlled.

STEP/SMOOTH (Step/Smooth switch)

Touch < SMOOTH > to select a line graph (smooth change), or touch
<STEP > to select a bar graph (stepped change).

Value:

STEP, SMOOTH

Multi Step Modulator menu

In the Multi Step Modulator screen you can touch <

▼

MENU > to

access the following menu.

(Thirty-second note)

(Dotted eighth note),

(Eighth note),

(Quarter note),

(Sixteenth note),

(Dotted sixteenth note),

Reset Value

Resets the step bar

Invert Value

Inverts the step bar in the vertical direction

Reverse Value

Inverts the step bar in the left/right direction

Shift Value R

Moves the step bar one step toward the right

Shift Value L

Moves the step bar one step toward the left

Preset...

Recalls a preset graph

Copy Graph...

Copies the step bar graph. You can copy a
graph between patches or tracks (A–D).

Hand Draw

If this is checked, you can draw the graph by
directly touching the step bars with your fin-
ger.

FWD1

1 2 3 • • • 14 15 16

FWD2

FWD3

1 2 3 • • • 14 15 16
2 3 • • • 14 15

1 2 3 • • • 14 15 16
1 2 3 • • • 14 15 16

BWD1

16 15 14 • • • 3 2 1

15 14 • • • 3 2

BWD2

BWD3

V-SYNTH_XT_e2 84 ページ２００５年３月２３日　水曜日　午後４時３９分