Enterasys csx5500 快速安装指南
QUICK START
36 CyberSWITCH
Dialing Out
1.
Double click on your new dialing icon to bring up the Connect To screen.
2.
Enter your Remote for your user name and Remote_S for your password.
3.
Double click on Connect.
4.
Once the call is connected, click Details to view the type of protocols in use. Click Disconnect to
disconnect the call.
disconnect the call.
IPX R
OUTER
WITH
D
IGITAL
M
ODEM
TO
A
T
ERMINAL
A
DAPTER
/M
ODEM
C
ONFIGURATION
FOR
S
ITE
“C
ENTRAL
”
The configuration on Central to allow IPX Routing to Remote is as follows:
1.
steps.
2.
Under Options, select the IPX protocol for the remote device, then:
a.
a.
Enable IPX Routing.
b.
Under IPX Internal Network Number enter the following value: 123456.
c.
Under IPX Interfaces add a LAN Interface and a hexadecimal IPX Network Number
(0130BABE).
(0130BABE).
3.
Under the Options menu, select Default Line Protocol. Increase the login timeout value to 45 or
50 seconds to accommodate the Digital Modem.
50 seconds to accommodate the Digital Modem.
4.
Under Security, select System Options and Information, then under System Information:
a.
a.
Set your System Name (Central). This matches up with Central device information
configured on Remote.
configured on Remote.
b.
Set your System Secret (Central_S). This matches up with Central device information
configured on Remote.
configured on Remote.
5.
Under Security, select Device Level Databases, select On-node Device Entries, then add a device
where the Device Name (Remote) must match the system name on Remote. When you add the
device you must then enter the following information:
a.
where the Device Name (Remote) must match the system name on Remote. When you add the
device you must then enter the following information:
a.
Under Digital Modem you must:
•
•
Select the line’s bearer capabilities.
•
Enter the phone number for the device.
b.
Under Authentication change CHAP Secret to match Remote’s system secret (Remote_S).
c.
Under IPX Information you must ensure that IPX routing is enabled.
C
ONFIGURATION
FOR
S
ITE
“R
EMOTE
”
ON
W
INDOWS
NT 4.0
This section describes how to set up your remote-access Windows NT 4.0 location from which you
will be dialing. The process of configuring remote access networking for Windows NT involves:
•
will be dialing. The process of configuring remote access networking for Windows NT involves:
•
installing a terminal adapter/modem
•
installing remote access networking
•
configuring a dial-out location
•
adding a dial-up entry