Enterasys csx5500 用户指南
USER’S GUIDE
442 CyberSWITCH
If you see this IP RIP initialization message, the IP RIP has initialized successfully.
3.
If the CyberSWITCH does not display the correct IP RIP Initialization message, and instead,
displays one or more of the following messages:
displays one or more of the following messages:
[IP RIP] Initialization failed, unable to allocate buffers
[IP RIP] Unable to open RIP/UDP port 512
There may be an a problem within the software. Contact Customer Support.
IP RIP O
UTPUT
P
ROCESSING
ON
A
LAN I
NTERFACE
To verify that IP RIP Output Processing (routes advertisement) is properly operational on a LAN
interface, the IP RIP processing must be successfully initialized. Also, a local IP host (router) must
be connected to the local LAN port on the system and capable of learning routes information via
RIP.
interface, the IP RIP processing must be successfully initialized. Also, a local IP host (router) must
be connected to the local LAN port on the system and capable of learning routes information via
RIP.
Below is an example of a configuration used to verify IP RIP output processing on a LAN interface.
It uses IP addresses specific to the example. Substitute the IP addresses of your network when you
perform the verification steps. It also uses the
It uses IP addresses specific to the example. Substitute the IP addresses of your network when you
perform the verification steps. It also uses the
netstat
administration console command. The
netstat
command displays the IP routing table of the system. Substitute the equivalent command
on your IP host.
.
.
1.
Make sure that a static route to the network 192.1.1.0 is configured on SITE1. On SITE1’s
administration console type:
administration console type:
ip route
<return>
If the route to 192.1.1.0 is displayed continue with step 3.
2.
If the route is NOT displayed, use the Manage Mode command
iproute add
to add the
static route.
"SITE1"
"SITE2"
100.0.0.1
ISDN
Host A
100.0.0.2
LAN 192.1.1.0
CSX5500
CSX5500