Enterasys csx5500 用户指南
Central Site Remote Access Switch 443
V
ERIFYING
R
OUTING
P
ROTOCOLS
IP Routing Operational?
3.
Determine if a local IP Host A has learned the route to 192.1.1.0 from System A. On IP Host A
type:
type:
netstat -r
<return>
If the route to 192.1.10 is displayed, the IP RIP output processing is operational.
4.
If the route is NOT displayed, try the following:
a.
Using the
ipnetif
Manage Mode command, verify that the IP RIP Send Control is set to
a RIP version that the IP Host can understand.
b.
If the command shows
Do Not Send
, the IP RIP output processing is disabled on the
interface. Correct the RIP Send Control configuration using CFGEDIT.
c.
If the command shows an improper version of RIP, correct the RIP Send Control to the
proper RIP version that the IP Host can understand.
proper RIP version that the IP Host can understand.
5.
Enter the
ip rip stats
administrative console command. Look for the
IfStatSentResponses
counter for the interface, which shows the number of RIP update
messages sent on the interface.
a.
If the counter is 0, enter the
ip rip send
administrative console command to force the
RIP update message to be sent immediately.
b.
Reissue the
ip rip stats
command.
c.
If the counter is still 0, there is an unexpected condition present within the CyberSWITCH
software. Contact Customer Support
software. Contact Customer Support
.
6.
If the RIP Send Control is set to “RIP Version 1” or “RIP Version 1 Compatibility,” use Manage
Mode to verify that the transmit broadcast address on the interface is set to a proper address
that the IP Host can receive (through issuing the
Mode to verify that the transmit broadcast address on the interface is set to a proper address
that the IP Host can receive (through issuing the
ipnetif
Manage Mode command).
7.
If the transmit broadcast address is not set properly, use CFGEDIT to correct it.
8.
Check the IP Host and ensure that it is set up to learn route information via RIP.
IP RIP I
NPUT
P
ROCESSING
ON
A
LAN I
NTERFACE
To verify that IP RIP Input Processing (routes learning) is properly operational on a LAN interface,
IP RIP processing must be successfully initialized. Also, a local IP router must be connected to the
local LAN port on the system and capable of propagating routes information via RIP.
IP RIP processing must be successfully initialized. Also, a local IP router must be connected to the
local LAN port on the system and capable of propagating routes information via RIP.
Below is an example of a configuration used to verify IP RIP input processing on a LAN interface.
It uses IP addresses specified to the example. Substitute the IP addresses of your network when you
perform the verification steps. It also uses the
It uses IP addresses specified to the example. Substitute the IP addresses of your network when you
perform the verification steps. It also uses the
netstat
command. The
netstat
command
displays the IP routing table of the system. Substitute the equivalent command on your IP router.