Enterasys csx5500 用户指南
USER’S GUIDE
448 CyberSWITCH
RIP. The output of an
ipx route
command contains a protocol (P) field for each route en-
try, which indicate if it is static (L- locally configured) or dynamically learned via RIP (R).
If it is learned via RIP, then basic communication between the CyberSWITCH and the local
NetWare server is operational, and it is uncertain why the NetWare server does not re-
spond to the ping request. Contact Customer Support.
If it is learned via RIP, then basic communication between the CyberSWITCH and the local
NetWare server is operational, and it is uncertain why the NetWare server does not re-
spond to the ping request. Contact Customer Support.
b.
Verify that RIP protocol is enabled by entering the following Mange Mode command:
ipxrip
Enable RIP if it is not already enabled.
c.
Using the
ipxnetif
Manage Mode command, verify that IPX RIP send and receive
control is enabled for the LAN interface.
Using CFGEDIT (under IPX network interfaces) enable RIP send and receive control if it is
not already enabled.
d. If the route does not exist, or the route is a static entry, then verify that the CyberSWITCH
and the local NetWare server are using the same packet encapsulation. To check the type
of encapsulation, use the
of encapsulation, use the
ipxnetif
Manage Mode command. If they are not using the
same encapsulation, then correct it either on the CyberSWITCH or the NetWare server.
e.
Verify that the CyberSWITCH and the NetWare server are using the same external IPX
network number for their mutual LAN (AA for this example). To check the network
number that the CyberSWITCH is using, use the
network number for their mutual LAN (AA for this example). To check the network
number that the CyberSWITCH is using, use the
ipxnetif
Manage Mode command. If
they are not using the same external network number, then correct the problem.
IPX R
EMOTE
LAN C
ONNECTION
To verify that IPX routing is properly operating over a WAN Remote LAN interface, a remote IPX
router (e.g., SITE1) must be operational and connected to the Remote LAN. The remote bridge
device (e.g., SITE2) must be operational and available to initiate connections.
router (e.g., SITE1) must be operational and connected to the Remote LAN. The remote bridge
device (e.g., SITE2) must be operational and available to initiate connections.
1.
From the router (SITE1), verify that the IPX Remote LAN interface has initialized. On the
router’s administration console type:
router’s administration console type:
dr
You should see messages stating that the IPX network has initialized successfully on xxxx.
Verify that “xxxx” is the network number of the Remote LAN.
Verify that “xxxx” is the network number of the Remote LAN.
2.
If the system does NOT display the IPX messages indicating successful initiation, try the
following:
following:
Check the IPX network interface configuration. Refer to
for
details.
3.
Determine the router’s (SITE1) MAC address. From the router, issue the command:
ver