Enterasys rbt-8100 安装指导

Chassis Back I/O Ports and Features

RBT-8100 Wireless Switch Installation Guide 1-3

 shows the back I/O Ports and features for the RBT‐8100 Wireless Switch.

The 250 watt power supply is rated for 250 watts of power at the following voltages and is rated as 
follows:

•

100–127 volts at 50/60 Hz; 5 A maximum

•

200–240 volts at 50/60 Hz; 2.5 A maximum

A. AC Power connector

F. Video connector (Not supported)

B. USB Ports 1, 2, 3 (Not supported)

G. NIC1 connector (1 Gbit)

C. Keyboard connector (Not supported)

H. NIC2 connector (10/100 Mbit)

D. Mouse connector (Not supported)

I. PCI card bracket (full height)

E. Serial port 

A

B

D E

F

G

H

C

I

Warning: Do not attempt to modify or use the supplied AC power cord if it is not the exact type 
required.
The power supply cord is the main disconnect to AC power. The socket outlet must be installed 
near the equipment and readily accessible.
If the power cord supplied with the system is not compatible with the AC wall outlet in your region, 
get one that meets the following criteria:
• The cord must be rated for the available AC voltage and have a current rating that is at least 

125 percent of the current rating of the server.

• The plug on the power cord that plugs into the wall outlet must be a grounding-type male plug 

designed for use in your region. It must have certification marks showing certification by an 
agency acceptable in your region.

• The connector that plugs into the AC receptacle on the power supply must be an IEC 320, sheet 

C13–type female connector.

• In Europe, the cord must be less than 4.5 meters (14.76 feet) long, and it must be flexible <HAR> 

(harmonized) or VDE certified cordage to comply with the chassis’ safety certifications.