Enterasys rbt-8100 安装指导
Wireless Switch Configuration Tasks
3-2 Configuration
•
Usernames and passwords for secure access using 802.1X authentication using PEAP‐
MSCHAP‐V2 and secure wireless data encryption using dynamic Wired Equivalent Privacy
(WEP)
MSCHAP‐V2 and secure wireless data encryption using dynamic Wired Equivalent Privacy
(WEP)
•
Directly connected access points
•
Distributed access points
The quickstart command displays a prompt for each of these items, and lists the default if
applicable. You can advance to the next item, and accept the default if applicable, by pressing
Enter.
applicable. You can advance to the next item, and accept the default if applicable, by pressing
Enter.
Depending on your input, the command also automatically generates the following key pairs and
self‐signed certificates:
self‐signed certificates:
•
SSH key pair (always generated)
•
Admin key pair and self‐signed certificate (always generated)
•
EAP (802.1X) key pair and self‐signed certificate (generated if you type usernames and
passwords for users of encrypted SSIDs)
passwords for users of encrypted SSIDs)
•
WebAAA key pair and self‐signed certificate (generated if you type usernames and
passwords for users of unencrypted SSIDs)
passwords for users of unencrypted SSIDs)
One of the questions the script asks is the country code. For a list of valid country codes, refer to
either the RoamAbout Mobility System Software Configuration Guide or the RoamAbout Mobility
System Software Command Line Interface Reference.
either the RoamAbout Mobility System Software Configuration Guide or the RoamAbout Mobility
System Software Command Line Interface Reference.
Another question the script asks is, “Do you wish to configure wireless?” If you answer y, the
script goes on to ask you for SSID and user information, for unencrypted and encrypted SSIDs. If
you answer n, the script generates key pairs for SSH and the administrative users you entered,
generates a self‐signed administrative certificate, and then ends.
script goes on to ask you for SSID and user information, for unencrypted and encrypted SSIDs. If
you answer n, the script generates key pairs for SSH and the administrative users you entered,
generates a self‐signed administrative certificate, and then ends.
quickstart Command Procedure
To run the quickstart command:
1.
Using the null modem cable shipped with the RBT‐8100, attach a PC to the RoamAbout
wireless switch’s serial console port. Use these modem settings:
wireless switch’s serial console port. Use these modem settings:
–
9600 bps, 8 bits
–
1 stop
–
No parity
–
Hardware flow control disabled
2.
Press Enter three times, to display a username prompt (Username:), a password prompt
(Password:), and then a command prompt such as the following:
(Password:), and then a command prompt such as the following:
RBT-8100-aabbcc>
Note: The quickstart command is for configuration of a new wireless switch only. After prompting
you for verification, the command erases the switch’s configuration before continuing. If you run this
command on a switch that already has a configuration, the configuration will be erased. In addition,
error messages such as Critical AP Notice for directly connected APs can appear.
you for verification, the command erases the switch’s configuration before continuing. If you run this
command on a switch that already has a configuration, the configuration will be erased. In addition,
error messages such as Critical AP Notice for directly connected APs can appear.
Note: Do not attempt to connect a monitor, keyboard, or mouse to the switch. Use only a null
modem cable connected to the serial console port.
modem cable connected to the serial console port.