Seiko Instruments slp120 用户指南
Chapter 2
Getting Started
User Guide
2-7
Loading a Roll of Labels
Follow the instructions below to load a roll of standard
address labels. Instructions on loading other label types
appear in Chapter 3.
address labels. Instructions on loading other label types
appear in Chapter 3.
Prepare the roll of labels
1 Remove the sticker from the beginning of the roll of
labels.
Note... Check to be sure there is a black sensor mark on
the label backing as illustrated on page 2-3.
the label backing as illustrated on page 2-3.
2 If needed, cut between the labels to create a “leader.”
If the end of the roll is not prepared as shown above, cut
between the labels leaving as much backing as possible
on the end of the roll to act as a leader.
between the labels leaving as much backing as possible
on the end of the roll to act as a leader.
Load the roll of labels
1 Make sure the power cord is connected and the printer is
turned on.
The green status light should be flashing.
2 Lift the base of the clear plastic label cover and rotate it
open.
Roll
Prepared end
Cut here
Roll
Waste
Spindle
Label
cover
cover
slp120-2.bk Page 7 Friday, March 3, 2000 12:40 PM