Axis M3203 用户手册
9
AXIS M32 Series
Setting the root password over a secure connection
To gain access to the product, the password for the default administrator user root must be set. This is done in the ‘Configure
Root Password’ dialog, which is displayed when the network camera is accessed for the first time.
Root Password’ dialog, which is displayed when the network camera is accessed for the first time.
To prevent network eavesdropping when setting the root password, this can be done via an encrypted HTTPS connection,
which requires an HTTPS certificate (see note below).
which requires an HTTPS certificate (see note below).
To set the password via a standard HTTP connection, enter it directly in the first dialog shown below.
To set the password via an encrypted HTTPS connection, follow these steps:
1. Click the
Create self-signed certificate button.
2. Provide the requested information and click
OK. The certificate is created and the password can now be set
securely. All traffic to and from the network camera is encrypted from this point on.
3. Enter a password and then re-enter it to confirm the spelling. Click
OK. The password has now been configured.
Note:
HTTPS (Hypertext Transfer Protocol over SSL) is a protocol used to encrypt the traffic between web browsers and servers.
The HTTPS certificate controls the encrypted exchange of information.
The default administrator user
The HTTPS certificate controls the encrypted exchange of information.
The default administrator user
root cannot be deleted.
If the password for root is lost, the network camera must be reset to the factory default settings. See page 35.
Adjusting the image
Open the
Live View page in the web interface and make the following
adjustments on the camera.
1. Loosen the locking screw and tilt adjustment screws.
2. Turn the lens to the desired position.
3. Gently tighten the locking screw and tilt adjustment screws to
2. Turn the lens to the desired position.
3. Gently tighten the locking screw and tilt adjustment screws to
secure the camera’s position.
4. Turn the image balance ring to set the horizontal position.
5. To set the focus and zoom, loosen the zoom and focus pullers
5. To set the focus and zoom, loosen the zoom and focus pullers
counter clockwise and rotate the rings. Lock the focus and zoom
pullers in position by rotating the screws clockwise.
pullers in position by rotating the screws clockwise.
Note:
Due to the dome's tendency to refract light, the image might appear slightly out of focus once the dome has been
mounted. To compensate, focus on an object slightly closer than the intended area.
mounted. To compensate, focus on an object slightly closer than the intended area.
To configure the password
directly via an unencrypted
connection, enter the password here.
directly via an unencrypted
connection, enter the password here.
To create an HTTPS connection,
start by clicking this button.
start by clicking this button.
Focus puller
Zoom puller
Locking screw
screw
Tilt adjustment
(on each side)
Image balance ring