UMAX 3000 用户指南

4

Changing the SCSI ID Number
Your scanner's SCSI ID setting is factory preset at #5.

5

! 

Check to see if this ID setting is used by another device connected to your

computer’s SCSI port.

! 

If SCSI ID #5 is not used, you do not need to change your scanner’s SCSI ID

number. You can directly proceed to hardware connection and software

installation. For installation instructions, proceed to Chapter 2 if you are

connecting to a Macintosh computer or to Chapter 3 if you are connecting to an

IBM PC.

! 

If you find however, that another connected device is already using SCSI ID #5,

then you must reset the SCSI ID on your scanner.

To reset the SCSI ID, do the following:

1.  Make sure the scanner power and the computer are off.

2.  Check the SCSI addresses of your external SCSI devices and look for an unused

ID number.

3.  Gently turn the SCSI ID switch until the chosen number appears in the switch’s

notch. If there are no other external SCSI devices except the scanner, you do

not need to change the factory preset address 5.

Note:  Do not use SCSI ID settings from 7 through F on your scanner. They are for

factory use only.

SCSI ID