UMAX 3000 用户指南

1

Your PowerLook 3000 scanner is extremely user-friendly. Hardware and software

installation can be completed in a few steps. In minutes you can start operating your

scanner and obtain impressive results.

This chapter tells you how to prepare your scanner for connection and installation. It

also gives some handling precautions and general care measures to ensure that your

scanner will stay in top condition at all times.

Unpacking Your Scanner
Ensure that your package contains all the hardware, software, cabling and

documentation you ordered. Check for any damage that may have occurred while the

package was in transit. If there are any missing or damaged items in your scanner

package, contact your dealer or the carrier of your package immediately.

Static Electricity Precautions
Static electricity (in your body) can cause damage to the electronic components on

the scanner's printed circuit board or the computer's interface card. Therefore, you

need to discharge static build-up from your body before handling any card or

component outside of its anti-static packaging.

To protect your equipment from static discharge, you are advised to closely follow

these measures below:

! 

Discharge any static build-up in your body by touching a grounded or anti-static

surface (such as a large metal object or the silver-toned expansion slot covers at

the rear of your computer.) Do this prior to removing any electronic

components from their anti-static bags.

! 

When handling any electronic components, avoid touching any metal part of the

component such as the gold “fingers” that plug into the expansion slot. It is

best to handle system components either by their edges or by their mounting

brackets.