UMAX powerlook iii 用户指南

1. Connect the power cord to a wall outlet.

2. Connect the other end of the power cord to the scanner.

3. Turn on the power of the scanner.

At power-on, the front panel indicators flash once. The power indicator then glows

and the ready indicator blinks. When the test is completed, the power and ready

indicators glow steadily.

Changing the SCSI ID Number
Your scanner's SCSI ID setting is factory preset at #5.

Check to see if this ID setting is used by another device connected to your

computer’s SCSI port.

If SCSI ID #5 is not used, you do not need to change your scanner’s SCSI ID

number. You can directly proceed to hardware connection and software

installation. For installation instructions, proceed to Chapter 2 if you are

connecting to a Macintosh computer or to Chapter 3 if you are connecting to an

IBM PC.

If you find however, that another connected device is already using SCSI ID #5,

then you must reset the SCSI ID on your scanner.

To reset the SCSI ID, do the following:

1. Make sure the scanner power is off.

2. Press the “+” or “-” buttons (above and below the number) on the SCSI ID

switch until an unused number appears in the switch's notch.

Note: Do not use SCSI ID setting from 7 through 9 on your scanner. They are for

factory use only.

SCSI ID