UMAX powerlook iii 用户指南

6

This chapter describes how you can use your scanner with your Macintosh computer.

1.  Ensure that the scanner’s SCSI ID is properly set. Refer to the “Changing the

SCSI ID Number” section in Chapter 1 for instructions on setting the scanner’s

SCSI ID.

2.  Connect the SCSI cable to your Macintosh’s SCSI port and connect the other

end of the SCSI cable to the scanner.

 

 

Note: 

If your scanner is not chained to other SCSI devices and is the last 

device, please connect the terminator to the remaining SCSI port of 

your scanner.

3.  Connect the power cord to the scanner. And connect the other end of the

power cord to a grounded power socket.

4.  Turn on the scanner power.

5.  Turn on the computer power .

Install the software in the following order:

1.  Image Application Software, e.g. binuscan PhotoPerfect, Adobe Photoshop.

2.  Then, MagicScan.

MagicScan is the interface used by application software to control UMAX scanners.

Its advanced controls allow precise adjustments in images even during the initial

scan.

For detailed information on installing the software, refer to the Installation section of

the Image Application Software User’s Guide and MagicScan Electronic Books.

Terminator