Zhone 1740 shdsl 用户手册

CHAPTER 16   Console Access 

To access the device via the console port the following are required: 

 

This terminal is essential to perform the initial configuration of the router. This is normally a terminal with a 
VT100 emulation program, such as Telix or HyperTerminal Edition 5. 

 

An RS-232, DB9-to-DB9 straight-through cable is only required if you need to connect the device to a 
VT100 terminal or equivalent. The cable is not supplied with the SHDSL router. 

16.1.1 Login 

For access by console, the console PC should be installed with a standard VT100 emulation program, 
such as HyperTerminal 5 or Telix. You must connect the router to a PC using a serial cable. The following 
steps describe how to establish the console session. 

STEP1: Run a standard VT100 program such as HyperTerminal (Ver. 5 is recommended), or Telix in the 

local terminal and select an open com port. 

STEP2: Enter the following port settings: 

 

Baud rate: 9600  

 

Data bits: 8  

 

Parity: none 

 

Stop bit: 1

 

Flow control: none 

 

STEP3: After the session parameters are set up, press the Enter Key. You will be requested to enter the 

user name and password.  

STEP4: After successfully logging in, the main menu will appear. 

 

66                                                                                      July 2004                                                                 1740-A2-GB20-00