Zhone 2208 用户指南
4-72
2 0 0 0 - A 2 - G B 2 1 - 1 0
Display Jitter Delay
To display the current jitter delay value, type “D” on the Voice Configuration
menu (Figure 4.54). The IAD displays the current value.:
Press any key to display the Voice Configuration menu and continue.
Voice Port Settings
To display the Voice Port Configuration Menu (Figure 4.75), type “P” on the
Voice Configuration menu (Figure 4.54). Voice port settings should be
changed only under certain circumstances. Please consult Paradyne technical
support prior to changing these setups.
changed only under certain circumstances. Please consult Paradyne technical
support prior to changing these setups.
Figure 4.75
Voice Port Configuration Menu
Set Start Mode (Loop Start/Ground Start)
To set start mode (for POTS only), type “S” on the Voice Configuration menu
(Figure 4.54) to display the Start Mode Selection menu (Figure 4.76).
(Figure 4.54) to display the Start Mode Selection menu (Figure 4.76).
Figure 4.76
Start Mode Selection Menu
NOTICE:
The loop start and ground start features apply to ATM signaling only.
Each option on this menu is described in detail below.
Set All Ports to Loop
Start
1
Type “1” to select Set All Ports to Loop Start. The IAD sets all ports to
Loop Start and saves the configuration.
2
Press any key to return to the Start Mode Selection menu or press escape to
continue with other voice path configuration.
3
Reset the IAD when you finish voice path configuration.