ZyXEL P-663H-51 用户指南
Chapter 9 Quality of Service (QoS)
P-663H-51 User’s Guide
94
Figure 51 Advanced > Quality of Service > QoS Classification
The following table describes the labels in this screen.
Table 37 Advanced > Quality of Service > QoS Classification
LABEL
DESCRIPTION
Class Name
This is the name of the classifier.
MARK
These columns are the QoS setting the ZyXEL Device uses for or assigns to the
packets of upstream traffic that match this QoS classifier.
packets of upstream traffic that match this QoS classifier.
DSCP Mark
This is the DSCP mark the ZyXEL Device assigns to the packets of upstream
traffic that match this QoS classifier.
traffic that match this QoS classifier.
Queue ID
This is the QoS queue the ZyXEL Device uses for the packets of upstream traffic
that match this QoS classifier.
that match this QoS classifier.
802.1P Mark
This is the IEEE 802.1p mark the ZyXEL Device assigns to the packets of
upstream traffic that match this QoS classifier.
upstream traffic that match this QoS classifier.
TRAFFIC
CLASSIFICATION
RULES
CLASSIFICATION
RULES
These columns identify the upstream traffic to which the QoS classifier applies.
Lan Port
This is the source Ethernet port of the traffic.
Protocol
This is the type of packets.
DSCP
This is the DSCP mark.
Source Addr./Mask
This is the IP address (and optionally the subnet mask) of the device that sent
the traffic.
the traffic.
Source Port
This is the port number that a device used to send the traffic.
Dest. Addr./Mask
This is the IP address (and optionally the subnet mask) of the device that the
traffic is going to.
traffic is going to.
Dest. Port
This is the port number on a device to which the traffic is going.
Source MAC Addr./
Mask
Mask
This is the MAC address (and optionally the subnet mask) of the device that sent
the traffic.
the traffic.
Dest. MAC Addr./
Mask
Mask
This is the MAC address (and optionally the subnet mask) of the device that the
traffic is going to.
traffic is going to.
802.1P
This is the IEEE 802.1p mark on the traffic.
Order
This is the classifier’s place in the classifiers list.
Enable / Disable
The classifier is active when this check box is selected.
Remove
To remove an entry, select its Remove check box and click the Remove button.
Add
Click this button to go to a screen where you can configure settings for a new
QoS queue.
QoS queue.
Remove
To remove an entry select its Remove check box and click the Remove button.
Save/Apply
Click this button to save the changes and have the ZyXEL Device start using
them.
them.