ZyXEL P-663H-51 Guia Do Utilizador

Chapter 9 Quality of Service (QoS)

P-663H-51 User’s Guide

Figure 51   Advanced > Quality of Service > QoS Classification

The following table describes the labels in this screen.  

Table 37   Advanced > Quality of Service > QoS Classification

Class Name

This is the name of the classifier.

MARK

These columns are the QoS setting the ZyXEL Device uses for or assigns to the 
packets of upstream traffic that match this QoS classifier.

DSCP Mark

This is the DSCP mark the ZyXEL Device assigns to the packets of upstream 
traffic that match this QoS classifier.

Queue ID

This is the QoS queue the ZyXEL Device uses for the packets of upstream traffic 
that match this QoS classifier.

802.1P Mark

This is the IEEE 802.1p mark the ZyXEL Device assigns to the packets of 
upstream traffic that match this QoS classifier.

TRAFFIC 
CLASSIFICATION 
RULES

These columns identify the upstream traffic to which the QoS classifier applies.

Lan Port

This is the source Ethernet port of the traffic.

Protocol

This is the type of packets.

DSCP

This is the DSCP mark.

Source Addr./Mask

This is the IP address (and optionally the subnet mask) of the device that sent 
the traffic.

Source Port

This is the port number that a device used to send the traffic.

Dest. Addr./Mask

This is the IP address (and optionally the subnet mask) of the device that the 
traffic is going to.

Dest. Port

This is the port number on a device to which the traffic is going.

Source MAC Addr./
Mask

This is the MAC address (and optionally the subnet mask) of the device that sent 
the traffic.

Dest. MAC Addr./
Mask

This is the MAC address (and optionally the subnet mask) of the device that the 
traffic is going to.

802.1P

This is the IEEE 802.1p mark on the traffic.

Order

This is the classifier’s place in the classifiers list.

Enable / Disable

The classifier is active when this check box is selected.

Remove

To remove an entry, select its Remove check box and click the Remove button. 

Add

Click this button to go to a screen where you can configure settings for a new 
QoS queue.

Remove

To remove an entry select its Remove check box and click the Remove button. 

Save/Apply

Click this button to save the changes and have the ZyXEL Device start using 
them.