ZyXEL 793H 用户指南
Chapter 4 Point-to-(2)point Configuration
P-793H User’s Guide
66
In a point-to-2points connection, the ZyXEL Device which has a physical connection to both
client devices becomes the server. The server controls some of the attributes of the DSL
connection, such as the transfer rate and the DSL operational mode.
client devices becomes the server. The server controls some of the attributes of the DSL
connection, such as the transfer rate and the DSL operational mode.
4.4 Point-to-2point Connection Procedure
Follow these directions to set up a point-to-2point connection.
1
2
3
.
4.4.1 Set up the Server
1 Log in to the ZyXEL Device that will be the server. (See
2 Click Network > WAN > Internet Connection.
3 Configure the VPI, VCI, Multiplexing, and Encapsulation fields for the point-to-
3 Configure the VPI, VCI, Multiplexing, and Encapsulation fields for the point-to-
2point connection. In the Encapsulation field, select either RFC 1483 or ENET
ENCAP. Select which line is the default remote node (1 or 2).
ENCAP. Select which line is the default remote node (1 or 2).
4 Scroll down to the Service Type section. The following screen appears.
Figure 24 WAN > Internet Connection > Service Type
5 In the Service Mode field, select 2wire-2line mode.
6 The Service Type field automatically selects Server.
7 Configure the rest of the fields, if necessary. For example, you might want to set the
6 The Service Type field automatically selects Server.
7 Configure the rest of the fields, if necessary. For example, you might want to set the
Transfer Max Rate to the maximum value for Line1 but set it to a smaller value for
Line2 (in case the client ZyXEL Device does not support maximum transfer rate).
Line2 (in case the client ZyXEL Device does not support maximum transfer rate).
8 Click Apply.
9 Browse to Network > WAN > More Connections and configure the settings for your
9 Browse to Network > WAN > More Connections and configure the settings for your
second remote node.