Dynaudio mc15 用户指南
Warranty
10
Dynaudio MC 15
The fuse (9) is placed on the rear panel of the speaker below the mains
power input. It can be changed without removing the panel.
power input. It can be changed without removing the panel.
To replace the fuse:
1. Switch off the mains power switch (7) and unplug the power cable (8).
2. Pull out the fuse holder (9).
3. Replace fuse with same type and rating
4. Push fuse holder back firmly until it is locked into position.
1. Switch off the mains power switch (7) and unplug the power cable (8).
2. Pull out the fuse holder (9).
3. Replace fuse with same type and rating
4. Push fuse holder back firmly until it is locked into position.
Service
There are no user serviceable parts inside the speaker. If service is
required please contact your local Dynaudio dealer.
required please contact your local Dynaudio dealer.
Recycling used products
This product is subjected to the European Union Waste
Electrical and Electronic Equipment directive (WEEE),
2002/96/EC.
This product must not be disposed of as unsorted
municipal waste but must be collected separately and
disposed according to your national regulations.
Electrical and Electronic Equipment directive (WEEE),
2002/96/EC.
This product must not be disposed of as unsorted
municipal waste but must be collected separately and
disposed according to your national regulations.
Warranty
The warranty only covers faults or defects in material and production.
Damage caused as a result of abuse, misuse or defective associated
electronics is not covered by the warranty.
All warranty claims must be accompanied by a copy of the original
purchase invoice and warranties are only valid in the country or market
of original origin and distribution. Should warranty service be required,
Damage caused as a result of abuse, misuse or defective associated
electronics is not covered by the warranty.
All warranty claims must be accompanied by a copy of the original
purchase invoice and warranties are only valid in the country or market
of original origin and distribution. Should warranty service be required,
it must be arranged for in the country of purchase by an authorized
Dynaudio dealer.
For additional information about the Dynaudio warranty conditions
please visit the Dynaudio website www.dynaudio.com.
Dynaudio dealer.
For additional information about the Dynaudio warranty conditions
please visit the Dynaudio website www.dynaudio.com.
Technical Specifications
System
Two-way active speaker
Frequency Response (+/- 3 dB)
55 Hz – 21 kHz
Input level for 85 dB SPL @1m
16 dBu RMS @ 0 dB setting
Power consumption
Idle: 10 W / Max: 90 W
Amplifier power
Tweeter: 50 W / Woofer: 50 W
Bass Principle
Bass reflex
Resonance frequency
58 Hz
Internal Cabinet Volume
4.8 liters
Crossover Frequency
1500 Hz
Crossover Slope
6 dB/oct
Tweeter
– Front
– Dome
– Voice coil
– Front
– Dome
– Voice coil
4 mm aluminium front
Esotec 28 mm/1.1'' soft dome, rear chamber
pure aluminium wire voice coil,
magnetic fluid
Woofer
– Cone
– Cone
– Voice coil
145 mm/5.7'', one-piece molded magnesium
silicate polymer cone
75 mm/3'', pure aluminium voice coil
Weight
7 kg / 15.4 lbs
Dimensions (W x H x D)
170 x 260 x 235 mm / 6.7'' x 10.2'' x 9.3''